How to do the maintenance and maintenance of the slitter？
Before use, the main parts should be inspected and filled with smooth oil. When inspecting the disassembly and assembly of automatic slitting machine, it is strictly forbidden to use unsuitable tools and unscientific operation methods; Cleaning and inspection; if the automatic slitting machine is not used for a long time, it is necessary to wipe all the bright exteriors, apply anti-rust oil, and cover the whole machine with a plastic cover.
If the automatic slitting machine is deactivated for more than 3 months, the anti-rust oil should be covered with moisture-proof paper; after the work is completed, carefully clean the equipment, wipe the exposed friction surface clean, and add smooth oil. To do the daily maintenance and maintenance of the slitter, do the following.
First, the electrical parts should be cleaned and inspected regularly;
Second, use high-quality slitting and cross-cutting knives;
Third, the daily maintenance of the slitting machine should be in place. The standard is that lubrication, cleaning, and clearing (no dust, no debris) are in place to ensure that the sliding part of the equipment is in good condition.
Article from Jiangmen Nantian Machinery Manufacturing Co., Ltd.：http://m.bitcoin8888.cn/
-
03-27
What is the reason why the tension of the film winder is too small?
There is sometimes no tension in the magnetic powder clutch.For this reason, there is a short circuit or poor contact. Check if the input wire is exposed and touch the mechanical body. Check for loose wire connections. Another reason is that the internal magnetic powder has now lost a part of the magnetic properties, and sometimes there is no phenomenon when tension occurs during the application process. In this case, it is considered to replace the new magnetic powder. 3. The magnetic po
-
03-27
Four operating requirements of the slitting machine
The most important performance indicators for fixed length slitting are the cutting accuracy and the consistency of the finished product length. The slitting length can be set continuously. If there is an error in the actual slitting length, it is easy to calibrate by setting parameters. Article from Jiangmen Nantian Machinery Manufacturing Co., Ltd.
-
03-27
What are the requirements for the process of the winder?
In the process of cutting the paper, the paper cutter will inevitably form a slit end face between the two cut papers. In theory, it can be cut into a plane, but in practice, it is often impossible to cut the unevenness. When the paper rolls are interlaced, the two rolls of paper are staggered together, and the width of the cut uneven paper rolls is inconsistent, which may cause trouble in use. The coated whiteboard paper is a coated paperboard having a bright coating on the coated side,
-
03-27
Working principle of rewinder PLC controller system
In the process of user program fulfillment, the rewinder does not change the status and data of the input point in the I/O image area, while other output points and soft devices are in the I/O image area or system RAM storage area. The status and data are subject to change, and the ladder diagrams listed above, the program performance results will work on the ladder diagrams that use the coils or data below; instead, the ladder diagrams below, The status or data of the rewritten logic coil can o